Skip to main content
Rocky Mountain Vending

Pricing and Configuration Verification

Other 3003 Table Top Merchandiser

OtherMedium confidenceExact parts not verified
Back to all issues

Pricing and Configuration Verification

A guide to verifying the physical switch configuration on the controller board to ensure correct pricing.

Low RiskOperator5-10 min
Controller5 stepsowner-basic
  • Switch positions do not resolve pricing issue

Checklist

Guided Diagnostic Steps

Work from low-risk checks toward technician-level inspection only when evidence supports it.

Printable checklist

You can read or print the route now. The first checkbox click opens the service contact gate.

lead gated
  1. 1

    Verify Service Mode Status

    owner-basicsafe-off

    Ensure the configuration toggle on the controller board is set to the normal operating position, not the service/programming position.

    Stop conditions
    • Switch breaks when toggled

    Expected: Machine is ready for normal vending operations.

    Evidence to note: note

  2. 2

    Inspect Pricing Switch Array

    owner-basicsafe-off

    Examine the small switches (often in a block) on the controller board. Note their positions. Refer to a manufacturer guide for the exact positional values (e.g., binary or decimal mapping) for your desired price.

    Expected: Switch positions match the required price point.

    Evidence to note: photo

  3. 3

    Adjust Switch Block

    owner-basicsafe-off

    Using a small non-conductive tool, carefully move the switches to the correct positions for your required price.

    Stop conditions
    • Switch breaks

    Expected: Switches are set to the correct configuration.

    Evidence to note: photo

  4. 4

    Verify Operation

    owner-basicsafe-on

    Close the machine panel, plug it in, and test a vend cycle with the correct coin amount.

    Expected: Machine accepts payment and vends.

    Evidence to note: note

  5. 5

    Technician Handoff

    manufacturer-or-licensedsafe-off

    Stop and hand off to a qualified technician. The switch configuration does not resolve the issue or a physical fault was detected.

    Expected: Technician takes over diagnostic process.

    Evidence to note: note

Tools for this route

No special tools listed

Parts status

Exact public parts list not verified yet. Use this route to identify the system before ordering.

Candidate areas for part verification

Controller and wiring componentsLogic BoardsPayment componentsPower components

Other Possible Issues

Switch routes if this symptom is not the closest match.

All issues
PaymentsPayment or money acceptance problemPowerNo power or dead display