Vend Motors Not Running (CREM Coils)
VendnetUSA VendnetUSA 15 H CSGF15
Vend Motors Not Running (CREM Coils)
The dispensing motors are not engaging when product selection is made, which could be due to mechanical binding or a control signal failure to the motor unit.
- Breakers tripping instantly
- Burning smell
- If the motors fail to engage after checking the circuit breakers and connections, a qualified technician must assess the motor coils and associated control wiring.
Checklist
Guided Diagnostic Steps
Work from low-risk checks toward technician-level inspection only when evidence supports it.
You can read or print the route now. The first checkbox click opens the service contact gate.
- 1
Starting with motor 1, attempt to gently turn the motor shaft clockwi...
operator-intermediatelowStarting with motor 1, attempt to gently turn the motor shaft clockwise by hand. Observe if the motor takes over and runs on its own after a slight turn.
Stop conditions- If the motors fail to engage after checking the circuit breakers and connections, a qualified technician must assess the motor coils and associated control wiring.
Expected: Initial condition is documented before deeper diagnosis.
Evidence to note: note
- 2
Inspect the relay panel for any tripped circuit breakers. Reset any t...
operator-intermediatelowInspect the relay panel for any tripped circuit breakers. Reset any that are tripped.
Stop conditions- If the motors fail to engage after checking the circuit breakers and connections, a qualified technician must assess the motor coils and associated control wiring.
Expected: Initial condition is documented before deeper diagnosis.
Evidence to note: note
- 3
Starting with motor 1, attempt to gently turn the motor shaft clockwi...
operator-intermediatelowStarting with motor 1, attempt to gently turn the motor shaft clockwise by hand. Observe if the motor takes over and runs on its own after a slight turn.
Stop conditions- If the motors fail to engage after checking the circuit breakers and connections, a qualified technician must assess the motor coils and associated control wiring.
Expected: Result is documented before continuing the route.
Evidence to note: note
- 4
Inspect the relay panel for any tripped circuit breakers. Reset any t...
operator-intermediatelowInspect the relay panel for any tripped circuit breakers. Reset any that are tripped.
Stop conditions- If the motors fail to engage after checking the circuit breakers and connections, a qualified technician must assess the motor coils and associated control wiring.
Expected: Result is documented before continuing the route.
Evidence to note: note
- 5
Check the plugs containing the orange, orange/green, orange/blue, and...
operator-intermediatelowCheck the plugs containing the orange, orange/green, orange/blue, and white/orange wires for damage or loose pins.
Stop conditions- If the motors fail to engage after checking the circuit breakers and connections, a qualified technician must assess the motor coils and associated control wiring.
Expected: Result is documented before continuing the route.
Evidence to note: note
Tools for this route
Location Help
Where to find this
Use this as orientation before touching the machine. It is location help, not a repair instruction.
Start at the front door payment column; match the display, keypad, coin, bill, or card device to the symptom before opening deeper panels.
- Drives the spiral or tray mechanisms to dispense products.
- CREM (Coin Relay Electronic Motor) coils
- Motor home switches
- Drive spirals
cabinet drink
control board generic
payment column
display keypadParts status
Exact public parts list not verified yet. Use this route to identify the system before ordering.
Candidate areas for part verification
Other Possible Issues
Switch routes if this symptom is not the closest match.