Cup Dispense Failure Flow
Automatic Products 211e 211e
Cold DrinkHigh confidenceExact parts not verified
Back to all issues
Cup Dispense Failure Flow
Traces the mechanical and electrical logic of the cup drop system.
Low RiskOperator5-10 min
Cup dispense1 stepsoperator-intermediate
- Cup drop motor is hot to the touch but not spinning
- Grinding noise heard during actuation
Checklist
Guided Diagnostic Steps
Work from low-risk checks toward technician-level inspection only when evidence supports it.
Printable checklist
You can read or print the route now. The first checkbox click opens the service contact gate.
- 1
Inspect Power Cord
operator-intermediatelowVisually and physically inspect the length of the power cord for cuts, kinks, or burn marks.
Flashlight or Work LightStop conditions- Exposed copper wiring
- Smell of burning plastic
Expected: Cord is fully intact with no exposed wiring.
Evidence to note: photo
Tools for this route
Flashlight or Work Light
Parts status
Exact public parts list not verified yet. Use this route to identify the system before ordering.
Candidate areas for part verification
Cup dispense componentsPower HardwareDoor Assembly HardwareCup Dispenser ComponentsCanister and Whipper AssembliesPower components
Other Possible Issues
Switch routes if this symptom is not the closest match.