Product Not Dispensing Diagnostic Flow
GPL Snackcombo II
Product Not Dispensing Diagnostic Flow
Non-invasive visual checks first, then harness and motor testing to determine if issue is mechanical, electrical, or sensor-related.
- motor-hums-but-does-not-rotate: stop-cycle-unplug-tray-motor-may-be-damaged
- repeated-jams-on-same-position: inspect-spiral-or-pusher-for-deformation
Checklist
Guided Diagnostic Steps
Work from low-risk checks toward technician-level inspection only when evidence supports it.
You can read or print the route now. The first checkbox click opens the service contact gate.
- 1
Inspect Power Cord
operator-intermediatelowVisually inspect the full length of the power cord for cuts, kinks, discoloration, or exposed conductors. Confirm it seats firmly in the machine inlet.
FlashlightStop conditions- cord-feels-hot-stop-and-unplug
- visible-exposed-wire-stop-and-unplug
Expected: Cord is undamaged and firmly seated.
Evidence to note: photo
Tools for this route
Location Help
Where to find this
Use this as orientation before touching the machine. It is location help, not a repair instruction.
Start at the affected product shelf or selection row; compare the tray, coil, and product path with a nearby working selection.
- Drives spiral, belt, or pusher mechanisms to eject product from tray positions.
- motor-and-pcb-assemblies
- ejector-shaft-gears
- wire-harness-clips
cabinet glass front
wiring harness
vend motor
spiral coilParts status
Exact public parts list not verified yet. Use this route to identify the system before ordering.
Candidate areas for part verification
Other Possible Issues
Switch routes if this symptom is not the closest match.