Machine Completely Dead
VendnetUSA VendnetUSA Vending
Machine Completely Dead
Systematic verification of power from wall outlet through main fuse to internal power supply.
Qualified technician handoff: stop before live electrical testing, sealed-system refrigeration work, compressor service, or protected-compartment access unless a qualified technician is handling the work.
- Fuse blows again immediately after replacement: STOP. Do not install a larger fuse. Indicates short circuit — requires thorough internal investigation or manufacturer support.
- Evidence of water intrusion in power area: STOP. Disconnect power at wall. Do not re-energize until water source is identified and area is fully dry.
Checklist
Guided Diagnostic Steps
Work from low-risk checks toward technician-level inspection only when evidence supports it.
You can read or print the route now. The first checkbox click opens the service contact gate.
- 1
Clear Product Jam
technician-advancedtechnicianWith power off, carefully remove the obstructing product or debris from the coil path. Do not use sharp tools that could damage the coil or tray. Re-seat the tray if it was displaced.
Stop conditions- mechanism will not move even with obstruction removed — mechanical damage suspected
Expected: Coil or pusher can be gently rotated by hand through its full range without resistance.
Evidence to note: note
Tools for this route
Location Help
Where to find this
Use this as orientation before touching the machine. It is location help, not a repair instruction.
Start outside the machine at the outlet and cord, then identify the power entry area before any protected-compartment inspection.
- Main power entry, line cord, main disconnect, and primary fusing
- power cord
- main fuse or breaker
- line filter
Do not open energized or protected electrical areas unless a qualified technician or licensed electrician is handling the work.
cabinet generic
delivery bin sensor
power supply
terminal blockParts status
Exact public parts list not verified yet. Use this route to identify the system before ordering.
Candidate areas for part verification
Other Possible Issues
Switch routes if this symptom is not the closest match.