Service Issues
AMS Sensit II Glass Front Vendor
Choose the problem first, then open the focused route for tools, safety notes, locator help, parts status, and checklist steps.
Issue Finder
What Problem Are You Seeing?
Search symptoms, filter by system, then open the matching route.
Compressor Will Not Run — Refrigeration Fault
Non-invasive checks to determine why the compressor is not starting, from thermostat settings through electrical supply to compressor health
Delivery Sensor Diagnosis — Remove Product Stuck
Diagnose why the machine persistently shows a remove-product message or fails to detect product delivery
No Power to Machine — Internal Diagnosis
Systematic check from confirmed-good wall outlet through the machine's power input path to isolate power interruption
Single Column Vend Failure
Diagnose why one specific column fails to dispense while other columns work normally
Controller or electronics problem
Use this when controller, harness, board, or low-voltage electronics evidence is involved.
Door, latch, or lock problem
Use this when the door, latch, lock, gasket, or seal is the visible problem.
Payment or money acceptance problem
Money, validator, coin, bill, or card-reader clues point to this route.
Machine Context
Areas This Machine May Use
Use these areas as orientation only. Open a specific issue before following diagnostic steps.